Globe valves are linear motion valves with rounded body structure. Their outlook is similar to other valves. Hence, they can only be differentiated on the basis of their internal structure. Globe valves are best suited for throttling service. Their flow characteristics permit accurate and repeatable flow control. However, caution must be exercised to avoid extremely close throttling when pressure drop exceeds 20%. This creates excessive noise, vibration and possible damage to valves and piping.
A lot of globe valve manufacturers do not recommend applications in excess of this due to possible damage to the valve. Globe valve applications are usually found in systems that require frequent vacuum, stroking or systems with varying temperature ranges.
TRUPPLY brings you a wide range of globe valves for convenient online shopping
Globe valves have a rounded body through which the fluid passes in a circuitous path. This results in more pressure drop through a fully open globe valve than similar sized gate or ball valve.
Globe valves are created with a disk that translates against a seat. The flow fluid is usually directed up through the seat and around the disk. Most large globe valves have direction arrows embossed on the body casting to show direction of flow.
Globe Valve Types
There are three main designs of globe valves:
Tee Pattern is the most common type of globe valve with a z-shaped diaphragm. The seat is oriented horizontally, allowing the stem and disk to travel perpendicular to the horizontal line. This also results in low flow, coefficient and higher pressure drop. Tee pattern globe valve is mostly used in throttling application.
Angle Pattern Globe Valve has ends that are at an angle of 90 degrees and fluid flows through this 90 degree turn. Their coefficient of flow is lower than WYE pattern globe valves. Angle pattern globe valves are useful in applications with pulsating flow.
WYE Pattern Globe Valve has seat and stem at a 45 degree angle. WYE pattern allows removal of debris and is useful in drain lines that are normally closed.
Globe Valve Design
Disk: Disk of globe valves are either ball, composition disk or plug disk. Ball disk is primarily used in low pressure application. Composition disk uses non metallic insert ring on the disk, which results in a tight closure. Plug disk provides better throttling and can be either long or tapered shape.
Seat: Globe valve seats are available in integrated or screwed configuration. Many globe valves have back seats inside the bonnet that provides a seal between stem and bonnet, preventing pressure build up against valve packing.
Stem: There are two types of connections for the disk and stem. The T-Slot or the disk nut construction. In the T Slot, the disk slides over the stem whereas, in the nut design the disk is screwed into the stem.
Globe Valve Video
Choosing a selection results in a full page refresh.
It wasnt fulfilled 12 days ago. I did not receive an order confirmation asking for ship date like requested. Order just supposed to be shipping today 12/18
This is a great compression fitting, and worked very well, sealed nicely, no gas leaks. My only problem was that I was replacing three gas pipes that were very close together, and the large size of the fitting made it hard to turn the nuts once it was in place since the adjacent pipes were so close.
